[cncmakers001]

welcome everybody
I own a 5 axis machine dmu 70 evolution deckel maho
I have a problem. There was a fire in the machine and the entire control was damaged. I bought a used control unit and upon working, I found it working for only 3 tries. When I activated the fourth and fifth X, a problem appeared. I found that the additional axes were not activated on the Sik chip.
I wrote to the company and it said it had stopped supporting the itnc530
Is there a solution to this problem, whether activation, crack, or software that solves the problem?

Maybe the used control unit you bought is only 3 axes version.
The prices of 5 axes and 3 axes are different, if the hardwares are the same, then can be upgraded by parameter setting, but need to ask the controller manufacturer.