Good morning,

I'm trying to load programs on my Hardinge CHNC1. I have another machine identical to it that I can load programs on but there are a few small differences like it has a parts counter and a cycle time counter when I hit the POS button. Other than that they are the same I keep getting alarm 086 I bought a new DB25 and DB9 solderless connectors so I can try the different variations of cable. I am not getting good voltage from pin 20 on my machine it's only showing 1 volt. So I did the work around pin 4 from the PC to pin 6&8. I left the cover open and it's showing 9 volts but still getting the alarm. I've tried changing parameters 002. Any and all help is much appreciated.

The previous owner deleted all the macro programs and now I can't use the bar feed without using a M00 and pressing collet close. If I program it M22 I get an alarm 1004 CLT DLY NOT PRG.

I have no way of manually punching in those characters to manually write a macro program and I also cannot edit 9000 programs.