586,937 active members*
2,272 visitors online*
Register for free
Login

Thread: How to Set Microstepping

Results 1 to 9 of 9

Threaded View

  1. 03-22-2024, 03:29 AM #1
    kolias
    kolias is offline Member
    Join Date
    May 2009
    Posts
    1333

    How to Set Microstepping

    I'm not there yet but I want to set the switch on the drivers before installing them however the setting for microsteps I’m used to is in 1/2" 1/4" etc format and the manual for DM556T stepper driver gives the microsteps in a format I’m not used to like shown in the attached.

    Are any tables available to find the corresponding values or perhaps calculations?

    Thanks
    Attached Thumbnails Attached Thumbnails Microstepping Screenshot 2024-03-21 221351.jpg  
    Nicolas
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Microstepping again?
    By Fastest1 in forum Stepper Motors / Drives
    Replies: 1
    Last Post: 03-09-2012, 10:58 PM
  2. microstepping
    By ljd10 in forum Automation Technology Products
    Replies: 15
    Last Post: 02-23-2012, 06:16 AM
  3. microstepping board
    By logix in forum Open Source Controller Boards
    Replies: 10
    Last Post: 10-21-2010, 11:18 PM
  4. A question about microstepping
    By stragenmitsuko in forum Stepper Motors / Drives
    Replies: 9
    Last Post: 05-23-2007, 03:25 PM
  5. Microstepping?
    By barkster in forum Stepper Motors / Drives
    Replies: 1
    Last Post: 05-16-2007, 05:27 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules