[jeeybee]

Hello!

I´m trying to get this controller to drip feed and by reading some threads here on cnczone I have found that G127.5 should be on and I found in the ladder that D400.0 set G127.5 and I then changed D400.0 to 1 and then its active in the ladder.

I can also send programs to the controller so that comunication is working at least.

I have tried al sorts of thing to make it receive the drip feed, for example setting it in tape mode and pressing start but nothing happends.
Is there an other procedure?

And is it the same comunication setting when drip feeding as then receiving a hole program?

I added some pictures of the controller so you can see what buttons and knobs that are available.

This is an old wood working machine I´m trying to use for milling and drilling large aluminium plates.

[jeeybee]

Actually it works now hehe, I noticed now when I downloaded a program and try to run it it waited for comunication so I just started the serial transfer again and then it works
Using serial to cnc in Fusion 360 by the way, very smooth