Well 470 views and no one can assist. I read a post by Burrman from like 7 years ago about flipping a 1 to a -1 to change the direction of the 4th axis but that was for a mill...but it got me thinking. After some phone calls to bobcad and much trial and error we were able to find the C to Z setting under (top left Cam defaults, Haas ST20Y, submachine, utms, workpiece device) The C axis is represented by the Z axis and this number was a positive 1. I changed this number to a minus 1 and posted but no change. I believed we were in the correct place so I saved and shut bobcad down and booted it back up. The refresh now saw the new setting and held it and now the post is spot on correct instead of backwards. Hope this experience helps somebody out here...thats why we do this.