[Pokeman1]

Hi, Has anyone experience of the TNC 415 .... and the NC Power Supply.
The machine stops with a error of the type "unstable power supply"
All the lights are on the NC supply board OK but the voltages measure a bit low..??
The pot on the board gives very little control, but the board seems to be working. It is just the outputs are lower that it says in the block diagram / voltage table in theTNC 415 manual.
Also in the block diagram there is a block labelled "RES" and referred to as reset...... What is this reset for...?? and when does it come into use. It is output PIN 7 of the 12 PIN plug.

[Pokeman1]

OR..... does anyone have a manual that shows the block wiring of the board that the 12 PIN plug plugs into......ie assume the NC board itself
Question is... what does PIN7 plug in to and connect to..?

[Pokeman1]

This is actual screen dump (attached) showing the error code when the problem occurred.
"PROCESSOR CHECK ERROR 1 M"
Manual says this is operating voltage out of range.
Question..... Does this refer to the NC Power Supply voltages out of range or does it mean some other Power Supply.
I do not know what all the other numbers on the screen mean or even if they relate to the error..???