I have a 6" superspacer (P/N 34123) 4th axis. When it's rotating slowly, it's losing steps. I think stepper motors have less power when moving in partial-step increments. Any ideas how to remedy this? Are there driver setting or something?
I have a 6" superspacer (P/N 34123) 4th axis. When it's rotating slowly, it's losing steps. I think stepper motors have less power when moving in partial-step increments. Any ideas how to remedy this? Are there driver setting or something?
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman
I figured it out. The DIP switches on the driver board were on the wrong setting..
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman