[Timdenton]

Ive had to replace the elte spindle on my axyz infinite router but the engineer who looked at the old one removed the wiring so Im not certain how to wire it. Could anyone take a picture of their own wiring for me to better understand the correct way?

I believe im connecting to the top row. Starting from left - black, red, brown. Green Earth obviously to the casing.

Am i right?

[Vlod]

If it is a three phase motor (you can verify it on VFD) it would only change direction… then swop two wires to get the rotation you need…

[Timdenton]

Thanks for the response!

If it is a three phase motor (you can verify it on VFD) it would only change direction… then swop two wires to get the rotation you need…

[CNCMAN172]

Thanks for the response!

Make sure you check the motor voltage configuration, this motor runs on two different voltages, which usually requires you to move jumper to set the voltage