425 oz Nema 23's are usually a poor choice, due to their high inductance, unless you run them at 60V-72V. Motors in the 300oz range will usually outperform them at lower voltages.
Thread: What stepper driver should I use
Results 1 to 4 of 4
Threaded View
-
05-14-2023, 12:59 PM #3
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Re: What stepper driver should I use
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
CL86T Driver Issues - Closed Loop Stepper Driver
By Dreco in forum Stepper Motors / DrivesReplies: 15Last Post: 08-22-2022, 10:08 AM -
Is there a way to up the driver current on the tx14207 stepper driver from my CNC 604
By Martijn_Beek in forum Stepper Motors / DrivesReplies: 5Last Post: 08-01-2019, 08:25 PM -
sla7033 stepper motor driver (unipolar driver?)
By Emanuelg in forum Stepper Motors / DrivesReplies: 1Last Post: 01-12-2017, 10:54 PM -
Replacing Syil Stepper Driver With Other driver. No Luck getting motion
By prcdslnc13 in forum Syil ProductsReplies: 7Last Post: 01-10-2015, 05:49 PM -
STEPPER DRIVER FAQ {Stepper/driver amp per phase match.
By huios in forum Stepper Motors / DrivesReplies: 0Last Post: 08-27-2006, 02:43 PM
Tags for this Thread
Posting Permissions
