My servos on my lc4896 run at 48v. I bet yours do too. They use encoders on the axis but I'm not sure about the drive motor.
My servos on my lc4896 run at 48v. I bet yours do too. They use encoders on the axis but I'm not sure about the drive motor.
I am trying to get specs on the servo motors, no luck so far.
All the documentation indicates encoders.
I intend to use either EMC or Mach3. I have both loaded on the PC.
Whichever is easist to get up to speed quickly.
The power indicator shows 48V, so I suppose that indicates something takes 48V - almost certainly the servos.