586,308 active members*
3,615 visitors online*
Register for free
Login

Thread: Eastern Air Device stepper

Results 1 to 2 of 2
  1. 09-29-2007, 05:07 AM #1
    jhelmstetter
    jhelmstetter is offline *Registered User*
    Join Date
    May 2005
    Posts
    22

    Eastern Air Device stepper

    I just bought 2 LA34CKK-P500E stepper motors off Ebay. The specs for the LA34CKK series make them very appealing for a CNC router project I'd like to start. These are rated at 5.0 / 10.0 amps and have a holding torque of 496 oz in UNI and 620 in BI. The question I have is this, did I make a mistake on buying them? In afterthought, I think that I would have to get a driver that can supply the 5 - 10 amps to make these things work well enough for a router. Am I correct in this thought?
    Reply With Quote Reply With Quote
  2. 10-04-2007, 05:56 AM #2
    DennisCNC
    DennisCNC is offline Registered
    Join Date
    Aug 2005
    Posts
    828
    Seem like good motors. Just get some Geckos and they will run fine.
    Dennis
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Info on Eastern Air Devices ??stepper??
    By mpmarino in forum Stepper Motors / Drives
    Replies: 6
    Last Post: 08-04-2014, 11:45 AM
  2. Full Time, South Eastern PA, North Delaware
    By John3 in forum Employment Opportunity
    Replies: 3
    Last Post: 07-13-2007, 12:51 AM
  3. Job opportunity for Operators in Eastern Maryland
    By ConKbot of Doom in forum Employment Opportunity
    Replies: 0
    Last Post: 03-01-2007, 09:47 PM
  4. Using a pc as a dro device..
    By hotponyshoes in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 4
    Last Post: 02-21-2007, 04:58 PM
  5. modbus device
    By Drew in forum Machines running Mach Software
    Replies: 14
    Last Post: 02-11-2007, 08:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules