I usually re probe for each program change then may run several parts off that program, I do not rezero for each individual part.
I also have most of my tools preset for the ones that I use most often.
This tool setter is new and I will figure it out but its going to take some time.......
Yeah, it changes things quite a bit, but they are very useful. I had to redo how I did tool lengths when I went to a BT30 machine and that took a while to set in.
If your tools are already set you should just be able to probe and go and skip zeroing the toolsetter.
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.