[Gynaekologe]

Hello,
I recently bought a Machbob3 breakoutboard with ESS smoothstepper from CNCroom and have a little problem with setting it up wth Mach4


On Y-axis I have two servo Motors from leadshine each one has an individual servo drive.

They both are getting the same signal only turning in opposite directions.
They are getting there step and dir signal from the MB3 Breakoutboard from output for Y axis (I tried also one motor on y axis output and one on A axiis but it didnt change the problem.)

Everything seems correctly connected I double -checked a lot of times.

I also connected one to output for Y axis and one to A axis and set this up in Mach4 with the same problem.

Each motor connected standalone is working but when both are connected MACH4 dont want to move the axis its showing up E-stop when trying to move the gantry. (ESS Reset velocity C) is showing up in LOG

Some of you guys maybe know a solution.

I attached some Pictures showing the wiring and also showing what errors Mach4 is showing.


Thanks for help in advance.

Best Martin