587,033 active members*
3,348 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > Leadwell MCV-OP, Control system wont start

Thread: Leadwell MCV-OP, Control system wont start

Results 1 to 10 of 10

Threaded View

  1. 09-23-2021, 07:39 AM #7
    jeeybee
    jeeybee is offline Member
    Join Date
    Dec 2006
    Posts
    112

    Re: Leadwell MCV-OP, Control system wont start

    If the manual is to be trusted it should be 0M-Model B or 00M-Model B
    It says series O-M om the front, se picture.
    Is there a page where I can see the inputs and check the at least the signal gets trhrough?
    I get no indication in the electrical cabinet when pressing the home swithches, maybe its only something wrong with the voltage feed to the switches.
    Cant find them in the schematics either :/ will have to do some searching when I have a bit more time.

    Attached Thumbnails Attached Thumbnails Front.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Leadwell MCV-OP w.Fanuc OM-A Control - no auto/mdi
    By MikkelRS in forum Fanuc
    Replies: 3
    Last Post: 06-15-2020, 11:20 PM
  2. Leadwell MCV 550 with a Fanuc 10MA control small c error on master PCB
    By trx-350 in forum Vertical Mill, Lathe Project Log
    Replies: 2
    Last Post: 12-31-2015, 07:18 AM
  3. LEADWELL MCV-OP WITH MITSI MELDAS M3 CONTROL
    By trebortrebor in forum Mitsubishi controls
    Replies: 1
    Last Post: 02-05-2014, 10:50 PM
  4. fanuc system 6t (RAMbold) wont start
    By leiryll in forum Fanuc
    Replies: 4
    Last Post: 10-13-2012, 01:54 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules