[crazybrit]

I have almost finished the conversion of this same mill to a Centroid Acorn setup. This mill is owned by the local high school First Robotics team. I can look and see if they have the original manual. The cost of the license for the software was excessive so that is why the conversion.

I sent @keffer322 a PM but doesn't look like he's logged in for a while.

I'm looking for an original controller for the eXpertMill VMC-0600. Cables also. It sounds like quite a few people convert to Centroid/etc.

If anyone wants to unload their original controller please send me a PM. I have a Wanted ad here: https://www.cnczone.com/forums/want-...ontroller.html