Hi Guys,

I'm in the process of swapping my DSP control system over to UCCNC with a UC300ETH UB1 Board. My end goal is full ATC and therefore I purchased an Chinese ATC spindle with ceramic bearings. I believe the ceramic bearings is the reason why I no longer have continuity down to the tool from ground and as result of this the old DSP tool setter is now useless. I wasn't keen on crock clips etc so bought a switched tool setter from China. Image Attached.My issue is I have no idea how to wire this into my UC300eth UB1 setup.

Can anyone help with an idiots guide for me on the wiring and ports etc.

Thanks
Paul