I have a Pcnc1100 S3, I bought a 3 flute 2" face mill to use on some 6061, It looks like I could run about 475rpms at 2ipm feed rate? does that seem about right? I don't know at what depth of cut.
Aluminum I ran max spindle speed with a 2" ripper mill. A good starting point would be max speed at .05 deep 1.8" step over at 30ipm. Flood cool if you can.I was using a solid r8 holder, not TTS
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.