[Eldon_Joh]

Hello awerby,

I should have included this in my first post... I attached a picture of some gable accents. We create these by laying down a large glue laminated block of timber on the cnc and cut each individual piece from the large block, it works incredibly well but takes forever at 1/8'' depth of cut currently, hence the reason for this machine.

you can't run them through a bandsaw first then cut them on the router?

i'm assuming you're talking about using a 7 inch long endmill to cut the profile of the 6" deep gluelam. so you are shaving off 1/8" of wood by 6" depth of cut correct? what is your feed rate?