At my new job we spend a lot of time adjusting tool offsets with the machine interface. I regularly adjust a tool offset by a couple tenths just to undo that offset adjustment a few minutes later. It is becoming incredibly frustrating as i often forget to remove the adjustment i made or i adjust the wrong offset because there are multiple tools that require this inefficient behavior. I could do what I want on a HAAS in a heart beat but now i'm working on a lathe that uses FANUC controls. I found this in the Manual:
G10L3;
P-L-;
T0101;
T0102;
T0103;
:
G11;
M02(M30);
But i'm not certain where to put my offset number. For example .0004 inches. Where would that go? These lathes do not use G91 or G90 so I would have to use a W or a U value. Please help, the inefficiency is starting to get to me. Thanks.