[nev25]

I'm sure this has been raised before But I cannot find a thread referring to it

dt101 - Stock size indicates the material is 16.25 in length
But the drawing indicates 32.5 in length(Double)

Anyone care to explain
I Assume the drawing is correct

ALSO Has anyone converted the drawing to metric???

[silentreaper]

I'm sure this has been raised before But I cannot find a thread referring to it

dt101 - Stock size indicates the material is 16.25 in length
But the drawing indicates 32.5 in length(Double)

Anyone care to explain
I Assume the drawing is correct

ALSO Has anyone converted the drawing to metric???

You are correct, the drawing is the correct size not the stock size.

If I remember right there is also a another small boo boo on the stock list, this could be the same one but double, triple and quadruple check everything before you start cutting.

I looked at the dxf's for 2 weeks calculating every little thing I could think of before I started cutting.


Reaper