I'm getting an alarm 057. This is on a First MCV1000 with an 18i-MB control. I ran a simple drilling program once and when I went to run it again I got the alarm. On the alarm message page it says 057 NO SOLUTION OF BLOCK END. I cannot find this alarm in any books and the machine won't let me run the program again even after I've reset everything. Also I have tried turning the machine off and back on again to see if it will clear...no luck. Anyone ever encounter this problem or have any suggestions??
Thread: Alarm 057
Results 1 to 3 of 3
Hybrid View
-
05-15-2007, 06:28 PM #1
Registered
- Join Date
- Mar 2007
- Posts
- 122
Alarm 057
-
05-15-2007, 07:57 PM #2
Registered
- Join Date
- Oct 2003
- Posts
- 45
Program Error (P/S) Alarm 057
Block end point is not found in direct dimension drawing programming.
-
05-17-2007, 05:29 AM #3
Gold Member
- Join Date
- Mar 2003
- Posts
- 2932
I have an idea: why not post the section of code where the alarm occurs; say 10 blocks before and after. Then maybe we can help.
Reply With QuoteSimilar Threads
-
Amp Alarm
By bbrreid in forum CNC Machine Related ElectronicsReplies: 4Last Post: 03-01-2012, 12:13 AM -
115 P/S Alarm
By VMC_Jeff in forum FanucReplies: 5Last Post: 03-17-2007, 12:02 AM -
alarm #180
By j-radkemachine in forum Haas MillsReplies: 1Last Post: 07-20-2006, 07:34 PM -
Ps-012 Alarm For T15
By Mircea in forum G-Code ProgramingReplies: 12Last Post: 06-15-2006, 05:01 AM
Posting Permissions
