[canaantr]

Anyone's laser controller is MPC03 or MPC05? How about them?

[samakthachai]

It is produced from step-servo company. Right

[canaantr]

Yes, many lasers made in china apply it and the software lasercut5. I can use it to meet my requirement. But what I want to know as a trader is, to those non-Chinese, is this product friendly/easy to use?

[FlyGuy007]

Well, my MPC03 arrived defective, trying to get a replacement now.

Thanks
Mike Purcell

[canaantr]

FlyGuy007, may I know did you purchase it directly from the factory or it's dealers?
Is it possible to know how much it cost?

[samakthachai]

I had ever contacted step-servo. MPC-03,This price is about RMB 3000 per set. ( 1 usd = 7.6 RMB) --->> 394.74 usd per set. It's not included shipping
and handling prices. I think it's more expensive.

[FlyGuy007]

I have no idea of the cost of my MPC03 card as it came as a part of my system. However, my case just gets weirder. My MPC03 card is defective for sure but its odd the way it works. The first two computers I tried it in, it would prevent the computers from even POSTing. Just nothing, no video nothing. The 3rd system I tried it in it would boot about 20% of the time. The system I finally put it in boots about 100% of the time, but does not recognize the hard drives about 30% and fails to detect or redetects various cards and controllers in the system at other times. Eventually windows gets so messed up I have to remove the card and restart the system. After a few boots the system detects everything normally and I can reinstall the card and start the whole cycle over. All in all a bad card I believe.

Certainly its not useabale in a production enviroment but it may be good enough to test the rest of the system

Mike