Oh and look at the Post Processor that you are using in Vcarve. There are a lot of Mach 3 Posts. Some in inches and the rest are no good.
Oh and look at the Post Processor that you are using in Vcarve. There are a lot of Mach 3 Posts. Some in inches and the rest are no good.
Lee
Bingo. The post processor was set to mm. Not sure how that got changed as I don't recall changing it to mm. So, you can design anything in one set of units, but the key is to select the same post processor. Thanks for your support in figuring this one out.
Stan