[4lowie]

Hi all, some time ago I built a CNC quilt machine for the wife. Works really well with mach3 and an old laptop, I'd like to replace this with an tablet. Sure the laptop works but I'd like to incorporate a tablet into the machine and make it look more professional. I do the stitch / tool path on another pc. I only use low power motors, 2 axis plus relay control so I was thinking about getting a tinyg board or similar to run the machine. I've been doing a fair bit of looking but can't find anything thing suitable to say, load the code into a tablet, set the positioning ect then press start and watch it do its magic.

Would appreciate any direction you guys can offer, would eventually like to make it simple enough so my wife can use I by herself......

Cheers Dave

[ger21]

I know that some people have run UCCNC on a Windows tablet with a UC100.

[4lowie]

I know that some people have run UCCNC on a Windows tablet with a UC100.

Thanks for that. Looking at a couple of things now....

Sent from my Moto G (4) using Tapatalk