OK, simply put I have the below setup

1) Using CorelDraw I draw a design
2) I sent to RDWorks
3) I take Screenshot of the CorelDraw Design in Colour
4) Using the ScreenShot I Open that in my RIP Software
5) I Print the image using my RIP Software and then this is the Final Correct Size
6) In RDWorks I resize the Design by measuring the Position of the Registration Lines on the Printed Piece.
7) I then try and position the Printout in the Laser so it cuts the Shape 100% correct

Yes a lot of steps but doesn't take too long until I get to Step 6 and 7, Positioning the piece in the Laser. As you can see with "Example_1.jpg" I print registration Lines along the Left and Top and at the moment I start the Laser and Pause and Move the piece, restart, pause and move again and continue doing this until the laser engraved lines match the Printed Lines. So the Top and Left side will always be in the same position as I have this setup on the Print side, So now I need to do the same thing with the Laser, have a method where I can push the Top and Left into a set position on the Laser. I know, its probably such a simple thing to do but my Brain is fried from everything today. BTW, the RIP Software doesn't have Import or Export and can only Open an Image so thats why I have to Screen Dump the design in CorelDraw.