Originally Posted by
MFchief
Hi All,
Does anyone know if you can set or change the 4th axis gear ratio in pathpilot, or maybe it can be handled in CAM?
I have a Tormach 8" fourth, which has a 90:1 ratio, but I'm in the process of modding a small 3" table with an arduino/stepper setup. It has a 36:1 ratio, but I'm thinking if I build it with a cable connector that match's the 1100, I could use it on the mill also. Since it only weighs about 10 lbs, sometimes that would be preferable to the big table.
Thanks
Terry