Thread: open and close suction vents

**jrslick22** · 12-14-2017, 09:47 PM

Ive pretty much solved this by having a homing routine then having a macro running to enable disable the output given on the x and y position.

**Dan911** · 12-15-2017, 03:09 AM

Originally Posted by jrslick22

Ive pretty much solved this by having a homing routine then having a macro running to enable disable the output given on the x and y position.

Not going to post your macro solution that could help others??

**jrslick22** · 12-15-2017, 12:17 PM

the dude who did the work for me did it on the condition that I protected his I.P. happy to point people in the right direction tho

**Dan911** · 12-15-2017, 01:06 PM

Originally Posted by jrslick22

the dude who did the work for me did it on the condition that I protected his I.P. happy to point people in the right direction tho

OK Np, If anyone similar to your needs can just use the macro Dezsoe posted... it works well.

Dan

**dezsoe** · 12-15-2017, 09:58 AM

Originally Posted by jrslick22

Ive pretty much solved this by having a homing routine then having a macro running to enable disable the output given on the x and y position.

:idea: Nice! That is what my macro does. The only difference is that the request was to check only the Y axis.

Re: open and close suction vents