has anyone attempted these with cut2d and an end mill bit?
has anyone attempted these with cut2d and an end mill bit?
Shouldn't be a problem to do that
Show us the drawing..........
Been doing this too long
don't have a drawing, was just curious since i don't have vcarve. what would be a good cut depth?
to begin, never more depth than diameter .004 feed per tooth. rpm according to surface feet per minute.
Been doing this too long
I use a diamond drag for anything that will be seen from at least a few feet away. .02 step over cross hatch pattern it works quite well for the signs I make
Attachment 382574