[Machinist16346]

I started in a school a few weeks back and we are manually programming G-code.
Here is my problem I make the progam and I used to having a simulator to watch it work. I end up with issues and I don't catch them until it's too late.

Question: is there a cheap simulator that I can download and watch the program run before I install it to the machine?


Very stressed out over the whole deal as of this point. Seems like I miss something like a . or a code or something.

Any help at all would be greatly appreciated(SERIOUSLY!!!)


Thank you

Steve
[email protected]

[Switcher]

http://www.ncplot.com/ncplotv2/ncplotv2.htm

15 day trial, no limits.



---------------------------------------------------------------------------------------------------------------

They also have a free version:
http://www.ncplot.com/ncplotfree/ncplotfree.htm

.

[Machinist16346]

I should have looked before I posted
But still stressed out any tips or advice is still greatly appreciated

[Al_The_Man]

Free one at MicroTechCnc
Al.

[rippersoft]

Ask and ye shall receive.

http://5axes.free.fr/devel_NCVisu_en.htm
http://www.cncsimulator.com/
http://www.betatechnical.com/autonc.htm

RipperSoftware