[dshowald]

any suggestions on programming a tapered hole in conventional programming?i know its easy enough but having a brain cramp.

thanks

[cincinnatimachine]

If a lathe, it is G1 first diameter X?? to second diameter X?? and new Z??

Colin

[dave3431]

What machine and control are you using.

Dave

[dshowald]

milltronics mill with a centurion 7 control

[LYN BYRD]

Are You Milling A Hole Thru A Plate?
What Is The Angle Of The Taper?

[AMCjeepCJ]

Did you mean conversational??

Goto your 'mill' start page and toggle through options... You'll have to program the hole as a 360 degree arc... If you're going to use multiple holes then do this step as a subroutine and call it up on another program...

My program kept crashing so I couldn't find it under the automated routines but if you look, I'd bet money it's an option on one of the start pages at the bottom...

Otherwise, if you meant regular G-code, I don't have a clue... It's so stinkin' easy in conversational that I never bothered to learn the hard way...