I am trying to add some line of codes into my post. I had done this previously, but had a hard drive crash and didn't have the modified post backed up.
Basically I want a window to pop up so the operator can check the Z-shift ( which is the material thickness plus the wasteboard thickness) and manually enter the value before proceeding. I have got the window to pop up but I can't get the text to print.
Here is a sample from my previous post that I modified.
G70
G90
[WINDOW ON]
[CLS]
[PRINT "CHECK THE HIGHLIGHTED LINE IN THE PROGRAM TO VERIFY"]
[PRINT "THAT THE CURRENT ZSHIFT IS CORRECT"]
[PRINT "IF THE THICKNESS IS NOT CORRECT, PLEASE CHANGE TO CORRECT"]
M00
SET ZSHIFT=0.250 (WASTEBOARD THICKNESS+MATERIAL THICKNESS)
This is what I am getting right now.
G70
G90
[WINDOW ON]
[PRINTCHECK THE HIGHLIGHTED LINE IN THE PROGRAM TO VERIFY]
[PRINTTHAT THE ZSHIFT IS CORRECT]
M00
SET ZSHIFT=.25 (WASTEBOARD+MATERIAL THICKNESS)
Here is what I have in the post. I need to get the quotation marks added:
n,measure_mode
n,absolute_coord
n,"[""WINDOW ON""]"
n,"[""PRINT" "CHECK THE HIGHLIGHTED LINE IN THE PROGRAM TO VERIFY","]"
n,"[""PRINT" "THAT THE ZSHIFT IS CORRECT""]"
n,"M00"
n,"SET ZSHIFT=.25"" ""(WASTEBOARD+MATERIAL THICKNESS)"
n,"[""WINDOW OFF""]"
Thanks,
Zach