I have a VMC 15 and when i go to cold start it in the morning i keep getting "X-axis Faults as Follows: Error# 3, Motor Overload." It happens every morning.(chair) But after a bit, it's fine. It still runs good parts. The Y and Z axis are fine. I can jog them around in the morning even when the X axis trips out. As soon as i flip the dial to the X-axis, it trips out.:bat: My voltage is good. The machine sounds great. Just not sure what the problem is. It takes about an hour to get the thing up and running in the morning. Any help would be greatly appreciated! Thanks.:cheers: