[Julien16410]

This is all you need, all the basic Parameter Settings are the same for all the 400Hz Spindles, just voltage and Amps that are different

Don't do a Reset unless you have to, sometimes doing this affects the order of how the Parameters get set

Huanyang Mactec54

PD000=0 for Parameter unlock ( 1 ) for Parameter Lock

PD001=0 (1 For Remote Control)

PD002=0 ( 1 For 0-10v Terminal Control or Remote Trim Pot Control )
( J1 Also Needs to be set for Terminal Control )

PD003=400

PD004=400

PD005=400

PD007=20

PD008=220 (120 If you have 120v VFD )

PD009=15

PD010=8

PD011=120 ( 100 Minimum Setting with Quality VFD, 120 is Safe)

PD13= 08 is for Factory reset, Only use this to set VFD to Factory Default Settings

PD014 Acceleration=12 ( Adjust to suit)

PD015 Deceleration=12 (Adjust to suit) gf
PD142= ( Motor Max Amps)

PD142=( 220vSet for your motor Amp Rating 2.2Kw Spindle 9 amp )
PD142=( 220VSet for your motor Amp Rating 1.5Kw Spindle 7 amp )
PD142=( 220v Set for your motor Amps Rating 800w Spindle 4 amps )
PD142=( 120v Set for your motor Amp Rating 800w Spindle 7 amp )

PD143=2 ( Motor Number of Poles)

PD144=3000 (Max Motor RPM) =3,000= (24,000)

PD70=0 ( This may need to be set to 1 if Control Voltage is 0-5v )ygfy&

PD72=400

PD73=120 ( 100 Minimum Setting )

Hello, i just receive and want to use my spindle that works with a similar VFD.

i am not sure to understand all that you say here...
just want to don't do failure

PD000 i can put the value to 1 after all other PDxxx setup to lock them and keep in security?

PD001 is to use the VFD onside controls?

PD002 i want to be sure : i will use a 0-10V PWM converter so i put it to 1 and i have to change the J1 (is it the jumper on the right of wires connexions?) in this case have i to put PD001 to 1 too? or if PD002 is in 1 status it is saying that i can use remote control too?

My spindle is a water cooled one, so i can use the 100 value to PD011 an PD073? or it is better to keep a minimum of 120?

i don't understand what value i have to put in PD142 setup? 220? or 7? my spindle is a 1.5kW and 220v type

For the PD143; how can i know number of pole? is it number of magnets? in rotor?

and the last one :
PD144 have to be setup to 3000 if my spindle max speed is 24000 RPM or i have to put 24000?

Thanks a lot, and sorry about my english, i'm from france and not know all technic words.

Have a good days !