I recently received the mill and started to mount all the accesories, after the manual oiler I started to mount the power drawbar but I followed the manual exactly, also watched a few videos (NYCCNC installation video) and I didn't noticed anything different to my setup, but my power drawbar is very lose, I don;t belive the mill can start with the power drawbar so lose, I'm sure it will vibrate as hell, something must be wrong !!!!
Please check out this video
https://www.youtube.com/watch?v=_dxGPWUWPZ4
Any help is appreciated !!!
PS I just received the missing TTS to R8 collet and I couldn't continue mounting the power drawbar when I first started now 2 weeks ago, now, after one hour of mounting (wires and other parts) I'm stuck again