Re: Okuma LB 15 II - problem with parameters
hy i don't know parameters for your cnc, but be carefull with this timers
common behaviours :
... 1) increase off timer = decrease frequency
... 2) timer off when axis don't move
... 3) change "on timer", thus lube duration
main factor when changing lube timers is how the machine works, because if the cnc is cutting, than "2) timer off" almost does not occure, and this avoids preesure drop among the lube pipes; as a result, when the pump pumps, at the end will lube
if cnc is not cutting often, thus there are time breaks, than pump must pump a little more so to build pressure among the pipes, and to lube at the end
so is important that lube will reach end points, and this is relative to machine usage
cutting a lot :
... off timer does not occure
... you may reduce frequency
cutting less :
... longer lube duration
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg