Does anyone else have a tailstock for their Tormach SlantPro 15L? After about 18 months of it sitting next to the lathe, I finally got around to setting mine up, and to my horror, it was WAY out of being anywhere close to centerline in X. It's very visibly off, in the X- direction, even with the adjustment fully maxed out to take it to X positive. There is no possible way to bring it into alignment. I disassembled it completely, and I'm convinced it's an error in the base casting of the tailstock, the part with with the dovetails that slide on the ways of the lathe. Has anyone else seen or heard of this issue? Pictures below.