586,701 active members*
2,574 visitors online*
Register for free
Login

Thread: M32 42 Parameter error

Results 1 to 2 of 2
  1. 10-13-2016, 09:23 PM #1
    DanOSB
    DanOSB is offline Registered
    Join Date
    Dec 2004
    Posts
    312

    M32 42 Parameter error

    Hi All,

    I have Mazak AJV 18 that was disconnected for over 4 months and we just powered it back up and installed new batteries

    we followed the procedure from http://www2.i-logic.com/manuals/Maza...0Procedure.pdf and we were able to do up to step 3 and now it wont let me go past that point..

    the fault code says "An error(s) is included in the machine parameter settings for the servo system."

    I have attached the images of what I see at the moment if that helps

    Thanks
    Dan

    Attachment 336558Attachment 336560Attachment 336562
    Reply With Quote Reply With Quote
  2. 10-25-2016, 04:09 AM #2
    Rokkin
    Rokkin is offline Registered
    Join Date
    Mar 2009
    Posts
    109

    Re: M32 42 Parameter error

    Did you load parameters?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fadal VMC 15 error parameter error
    By jerodor in forum Fanuc
    Replies: 1
    Last Post: 06-12-2014, 05:22 AM
  2. 8055T v3.13 E-504 error in parameter
    By captain_bas in forum Fagor Automation
    Replies: 8
    Last Post: 12-30-2012, 08:02 PM
  3. 63 parameter error
    By FN Smith in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 06-15-2010, 07:16 PM
  4. machine parameter error
    By Runner4404spd in forum Fadal
    Replies: 3
    Last Post: 03-06-2009, 04:33 AM
  5. Memory Parameter Error?
    By John3 in forum Fanuc
    Replies: 6
    Last Post: 09-07-2007, 03:17 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules