I set up a plate marker on my plasma table. Everything working using MP1000 post processor.
My scribe is on a floating head that is against spring pressure. I would like to set up different "Jet Tools" that have different feeds and cut heights depending on the result I want. A lower Z will push down more on the spring causing a deeper mark.. The "Cut Height" option under Tools does nothing. I have to go into the post processor to change the Z offset each time. The torch is also on a floating head that sets 0 before the start of scribe.
How do I activate the "cut Height" in the Tool menu? I assume a change in the post processor but I don't know what to change.
TIA