[dinesh]

Dear Sir.
Fanuc 10T PMC PARAMETER PAGE "DATA TABLE CONTROL DATA" :
I need information regarding PMC PARAMETER PAGE " DATA TABLE CONTROL DATA", I am not able to enter data on Table. NO.0., The cursor move between

Column
ADDRESS to PARAMETER to NO.OF DATA to OFFSET to SPECIAL .
But Cursor does not move to TABLE NO.0 Column.
I checked with enabling 8000 parameter and emergency state , Also edit mode with edit key on. But not succeed .
Any help on this greatly appreciated


Thanks with regards

[ittco]

Dear Sir.
Fanuc 10T PMC PARAMETER PAGE "DATA TABLE CONTROL DATA" :
I need beaver turning centeres fanuc10t parameters

My lathe cnc ram parity error
Fs10tf 1315d

Thanks with regards[/QUOTE]