Originally Posted by
premier_industr
That was my problem.
After referancing out the machine I should have been typing in G92 X0 Y0.
Also found that after refing the machine, type in G52 X0 Y0.
Pretty much the same code as the G92 but different.
My next question, how do you start writing a new program into memmory ?
For instance, on a Fanuc, in edit mode, type O1234 ( prg # ) and then ; ( EOB ) that gives you a new program to start writhing in.
How do you do this on a Yasnac ?
Thanks for all your help on the previous post.
With out you help I would have gone nuts.
Nuts???? That is the definition of being a Machinist, LOL. We have to be NUTS to be doing this for a living :rainfro:
I'll really have to dig for that one. I used to write all my stuff with BCC V19 then use the RS232C Communications.
BRB with some information for you.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com