[KrashKing405]

I need some help getting info on this stepper [photo attached]. It has 5 wires, says it is DV24V 0.32A 1.8deg/step. Made by Toshiba. has HPM-215-24A on one part of the sticker, and FH7-1342 CLASS E lower down. Anyone have any ideas, or a place [other than google] to start looking??

[hesham morsy]

Javascript Page to determine stepper wires
http://www.piclist.com/techref/io/stepper/wires.asp

[KrashKing405]

Thanks for the info, was looking more for something that would hsve a spec sheet for it. Will use that web page for sure though.

[KrashKing405]

Ok, sorry for the double post here. That webage was not much help. The stepper has 5 leads. I did part 1, sent me to part 2, all connections had "dentents", gave me an error saying I did it wrong, that it only works for bipolar motors. Went back to test again, same result. Must be a unipolar then.

[hesham morsy]

:bs: do not ask me for translation i m from Egypt

http://www.hobbycnc.hu/CNC/Motor/Motor.htm
47.
Típus: Toshiba HPM-215-24A (JAPAN)
- Tekercsrendszer: két fázisú, Unipoláris (5 kivezetéses)!!!
- Lépés: 1.8°/Step
- Feszültség: 24V=
- Áram: 0.32A
- Tekercs ellenállása: 5x75 Ohm/fázis
- Súlya: ~0.4kg
- Motortengely átmérője: 6.4 mm
- Felfogó csavartávolságok: 4x47mm (M5 menetelt)

[KrashKing405]

Oh my god, you rock man! THANKS!