Hi, i am trying to get my code on to a floppy after i generate it in fusion 360. i am using a mac the a usb floppy drive and can't get the code to transfer over to the floppy. I am using the haas generic post in fusion and i open it fine and read it not the desk top but not once it is transfer to the floppy, the machine is 2003 tm1. When i load the disk in the machine i can pull a file up but there is no code in the file. i am using a SABRENT floppy to usb. i can transfer other document on the disk and read them but no the post from fusion.