[menzzer37]

I've been upgrading and expanding my shop over the last few years. I don't want to sell my PCNC1100 but I added a new Hurco VM10i and a larger chucker lathe. I don't have much use for my Tormach Slantbed anymore. I am kicking around to see what it may be worth or if there is any interest. It's very low mileage and turned mostly Grade 2 titanium. I have the kennedy auto air closer on it. It's not got the full enclosure, just the original chuck cover guard. I used it in the gang configuration so no toolpost or turret. Value? No tooling included except the closer.

[smokediver576]

Where are you located? Pictures.....

[menzzer37]

I'm in Indianapolis, I'll get pictures later. People are asking, but again tooling only includes:

Air closer
Gang Adapter Plate
Custom coolant manifold w/straws for gang setup
I'll include a monitor too (17" LED)

[smokediver576]

I'm in Indianapolis, I'll get pictures later. People are asking, but again tooling only includes:

Air closer
Gang Adapter Plate
Custom coolant manifold w/straws for gang setup
I'll include a monitor too (17" LED)

What about the PathPilot controller?

[menzzer37]

Yeah...kinda useless without it!

[smokediver576]

Yeah...kinda useless without it!

You would be surprised at how many folks keep the controller.....

[smokediver576]

Do you have it in a location that it can be rigged and put on a pallet for shipping? Basically are you in a shop with truck freight access or in a garage?

[menzzer37]

Yes it can be rigged. It's in a commercial machineshop with no dock. You will either need a liftgate or a forktruck.

[smokediver576]

PM me what you're thinking on price. I need to see what it's going to cost me to fly up and check the machine and rig for shipping back to Georgia. I may drive up and load in the back of my truck and bring it back. Anyone near you have a forklift we could borrow to load it on my truck?

[David Bord]

I just purchased a SL15 lathe 1 year old, full enclosure, 3 tool gang tooling, QCTP Phase II 250 sized tool post and 10 holders. Several high end Iscar tools and similar along with several inserts. (Probably 2k in tooling)

I paid $10.5k and the machine was in incredible shape.

David

[imp22b]

I'm interested in your lathe. I'm located in Indiana south of Indy. I sent you a message with a price request.

[menzzer37]

Not to bump, but sold

[tmarks11]

excellent.

Why kind of chucker lathe did you get?