[serickson]

Before wiping out all parameters & reloading, I tried to copy PC Timer, Keep Relay, etc.

When I came to Data Table, I could not get to the data for the individual entries - this control (Mori-Seki MV Junior with Fanuc 10M control) pendant does not have the expected UP & DOWN arrow keys used for PAGE, it does have the four left/right keys, with single & double arrow heads.

I looked at the other Fanuc controls in the shop, and they all had the PAGE keys, allowing me to get the desired Data Table info.

I have tried using the shift key + several other keys, but nothing I have tried works.

What is the secret technique I am missing?

Cheers,
Steve

[Heavy_Metal]

Hi,

Do you have the Maintence manual B-54815, you can download it at the link below.

Check page 336-337

Fanuc 10 11 12 Maintenance Manual 54815E - CNC Manual

Regards,
Heavy_Metal.

[serickson]

Heavy_Metal,

I have a GE version of the manual, GFZ-43815E/05, looks to be the same, as pages 336 & 337 reference the 'PAGE' key (down arrow) that my machine DOES NOT HAVE.

So I'm still stuck getting to the Data Table area.

Cheers,
Steve

[williamtraughbe]

Try switching to MDI mode find pwe parameter change from 0 to one. This will cause am alarm. Now find the (pcprm) soft key. Then you will see the selection for T/D/k/ and another letter. Select that then key in the data. Change pwe back to 0. Then restart the machine. Good luck.

[tmbruno28]

Push at the same time the 2 arrows keys ( cursor and line) and your page will turn

Heavy_Metal,

I have a GE version of the manual, GFZ-43815E/05, looks to be the same, as pages 336 & 337 reference the 'PAGE' key (down arrow) that my machine DOES NOT HAVE.

So I'm still stuck getting to the Data Table area.

Cheers,
Steve

[williamtraughbe]

Push at the same time the 2 arrows keys ( cursor and line) and your page will turn

Steve,
At the bottom of the (CRT) there should be (soft keys). They are situated left to right. On each end over keys Im assuming that would be your up and down pages you are refering to. When you press those the key options should show on the bottom of the screen readout.
Goodluck
Ray

[serickson]

Pressing both arrow keys at the same time did the trick.

Cheers,
Steve