[bobleecnc]

Hi Eric (AKA) Balsaman do you know if there have been any further releases of turbocnc version 4 since the original beta?
I was one of the original beta testers for ver.4 but had to have
Dave take me off the email list because I was getting duplicates of all my email and it was fillimg up my inbox . Since then I've tried to email Dave and have gotten no response ,do you have any news on the progress of the constant contouring feature thats rummored?

Bob

[balsaman]

Yes there have been several betas released. It should be very soon that we see a version 4 for the general public. It's very good but no CVC so far. I think you will need to wait for version 4.1 for that. CVC was not sheduled for this release, nor have they been writing any CVC code thus far.

Eric

[bobleecnc]

Thanks Eric for the reply is there any way I can get those new beta releases or at least the latest one. I PM'ed Dave but I'm not sure if He's monitoring right now.

Bob.