[Megaplow]

Hey All,
I have a Chinese laser with a PHLC980 control board. Recently I have been using my machine to cut out printed graphics. Aligning the machine to the printed graphic always has a bit of error. Is there any way to add a camera to the machine and have it auto align to the graphics? Going the extra mile would be to add the auto tracing tools the ship with the glowforge. I am hoping there is some open source thing downloadable from github to get this thing done.

Similar to this:
https://www.youtube.com/watch?v=ZX9B0rms5lg

Thank you
Joe

[AmyThunderlaser]

Hey All,
I have a Chinese laser with a PHLC980 control board. Recently I have been using my machine to cut out printed graphics. Aligning the machine to the printed graphic always has a bit of error. Is there any way to add a camera to the machine and have it auto align to the graphics? Going the extra mile would be to add the auto tracing tools the ship with the glowforge. I am hoping there is some open source thing downloadable from github to get this thing done.

Similar to this:
https://www.youtube.com/watch?v=ZX9B0rms5lg

Thank you
Joe

Hi Joe
Please find below video:
https://www.youtube.com/watch?v=vnMZ...OsVAbM&index=8