I have just purchased a used HRT 210 it works great, however I am makeing diamond lead screws and my table rotated a total of 7200 degrees, after I am finished with the thread I home the Table (G91 G28 A0) and it seems to have to unwind that entire 7200 degree rotation. Is there a way to set a parameter or something of this nature so the table can find its home in a single rotation?
Thread: HRT 210 homing
Results 1 to 2 of 2
-
12-07-2006, 05:49 PM #1
Registered
- Join Date
- Nov 2006
- Posts
- 3
HRT 210 homing
-
12-07-2006, 07:44 PM #2
Moderator
- Join Date
- Mar 2003
- Posts
- 4826
IIRC, someone mentioned that there is a setting, #108 for "quick rotary G28".
I don't think I've tried it since I heard about it to know if there are any more details to add about how to use it.First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With Quote
Posting Permissions
