Hi everyone,
Does anyone can help me to create toolpath for the ID groove with 45 DEG.
I attached the pic and Gibb file
Thanks so much
Thread: ID Groove toolpath with 45 DEG
Results 1 to 4 of 4
-
09-07-2015, 03:17 AM #1
Registered
- Join Date
- Mar 2014
- Posts
- 9
ID Groove toolpath with 45 DEG
-
09-18-2015, 02:43 PM #2
Member
- Join Date
- Aug 2006
- Posts
- 138
Re: ID Groove toolpath with 45 DEG
See "Rant gibbs vs mastercam!" post I answered your question there. Sorry.
"Teach the ignorant, care for the dumb, punish the stupid."
-
09-19-2015, 05:52 PM #3
Registered
- Join Date
- Mar 2014
- Posts
- 9
Re: ID Groove toolpath with 45 DEG
Can you help me to fix the I.D toolpath??
Originally Posted by Species8472
ThanksAttachment 292866
-
09-21-2015, 03:05 PM #4
Member
- Join Date
- Aug 2006
- Posts
- 138
Re: ID Groove toolpath with 45 DEG
Issues were numerous. The groove tool will have to be a special Iscar or Manchester groover. The RPMs are off the charts. When ever you are using roughing operations you must have rough stock defined. You also were defining Xr stock, Z stock Finish stock all at the same time. Just use finish stock for now. So compare the operations one by one and note the differences. Also compare the tools I defined with your original ones.
"Teach the ignorant, care for the dumb, punish the stupid."
Reply With QuoteSimilar Threads
-
Getting in the groove
By mountaindew in forum SprutCAMReplies: 35Last Post: 05-28-2015, 08:35 PM -
oil groove
By riverracer in forum MastercamReplies: 1Last Post: 07-30-2010, 03:22 AM -
Groove on OD
By Rzadziu in forum FanucReplies: 15Last Post: 07-18-2010, 01:35 PM -
Groove on O.D
By dpark1 in forum SolidworksReplies: 1Last Post: 07-31-2008, 11:31 PM -
O.D. Groove
By Stickmchn in forum G-Code ProgramingReplies: 10Last Post: 12-08-2007, 11:29 PM
Tags for this Thread
Posting Permissions
