Originally Posted by
tienduongcnc
sorry, may i confirm your problem?
a. PMC softkey stills show up on [SYSTEM] group.
When you push [System] => [PMC] ==> only PMC Diagnosis screen shows up
b. PMC softkey not exists in [SYSTEM] group.
for case a
Is that a Makino machine?
With Makino machines, they used dedicated CNC software from Fanuc, different type of PMC controller
for example, Makino machine BN8-85A10 (Fanuc 16MA), which uses PMC BIT controller: only PMC diagnosis is shown, no screen for PMC parameters, PMC ladder.
for case b => i have no information, hope that other guys can help you