[spincaster]

I have a relatively new (May2015) G0704 and recently purchased/installed a Benchtop Precision belt drive conversion kit. The motor/controller has humming/buzzing noise and just now blows fuses. I'm not sure what is causing this and have no idea of where to start looking.

Anyone had experience with this? Thoughts? Solutions?

[109jb]

if it is that new, call Grizzly tech support.I have several Grizzly machines and have called them a few times and they have always been very helpful.

[spincaster]

As it turned out, Grizzly tech support were very helpful in diagnosing that the motor is bad. With both the included fuses blown I had to hunt down fuses which turned out to be expensive $1.80 each and hard to find. Anyone with a G0704 might want to get some spare fuses. The controller is a simple variable voltage unit so was easy to test with a multi-meter. They are going to supply a replacement motor on warrantee. They are waiting for a shipment of parts due in August so I just have to wait for it to arrive. Waiting will be the hardest part.